Gas boilers | Jeremias Group - chimney systems

The burners can be gas or diesel, which does not affect the characteristics of the chimney, except in the case of gasoil with high sulphur content that requires the use of stainless steel AISI 316L in its inner wall. The chimneys should always be double-wall both inside the building and outside.

Read more

Condensing boilers | Jeremias Group - chimney systems

The exhaust gas in the condensing boilers cannot escape through the natural chimney draft. Therefore a blower pushes the exhaust gas through the pipes with a maximum pressure of 200 Pascal. The exhaust pope must be such that it is suitable for over pressure and at the same time not let the condensate or exhaust gas escape.

Read more

Dampers and Valves | Jeremias Group - chimney systems

Dampers. Flue gas dampers (butterfly valve) are installed in the connection pipe between a boiler and the chimney and close the flue gas path, if the chimney is no longer in use. This prevents the cooling down of the heat generator and the installation room, which helps to save energy. Furthermore in the case of cascade systems…

Read more

Wall hung boiler | Jeremias UK - chimney systems

Jeremias offers corrosion resistant exhaust systems made of stainless steel and polypropylene as pressure tight exhaust solutions for condensing boilers. Depending on the circumstances and planned air supply you can select the perfect chimney kit for your condensing boiler.

Read more

Exhaust gas boilers | Jeremias UK - chimney systems

The burners can be gas or diesel, which does not affect the characteristics of the chimney, except in the case of gasoil with high sulphur content that requires the use of stainless steel AISI 316L in its inner wall. The chimneys should always be twin wall flue systems both inside the building and outside.

Read more

Condensing boilers | Jeremias® Exhaust Systems

The high efficiency of the condensing boilers results from the fact that heat produced in the condensation process is used to increase heat supply. The exhaust gasses are cooler and hence the maximum condensing happens in the chimney. The condensate then flows along the internal wall of the pressure-tight pipe, and back to the boiler for disposal.

Read more

Steam boiler | Jeremias UK - chimney systems

In the event that the operation of the installation is a forced draught, a silicone gasket must be included in the joints of the chimney to ensure its correct operation in excess pressure. The burners can be gas or diesel, which does not affect the characteristics of the chimney, except in the case of gasoil with high sulphur content that requires the use of stainless steel AISI 316L in its interior wall.

Read more

JEREMIAS BIOMASS SYSTEM SOLUTIONS CHIMNEY SYSTEMS

Jeremias Chimney systems fuel compatibility* Please take this information as general reference. systems specially with Biomass Boilers and CHPs. Jeremias gives an standard guarantee of 10 years for its products using officially approved fuel typesless with

Read more

Gas boiler goes up chimney in house - Hot Water and …

We're in Purley, Surrey. Our customer has an old atmospheric Potterton Kingfisher II 100,000 Btu in the basement, connected to the internal chimney system. We could have resited the new boiler on the external wall but the flue outlet would have detracted from the external aesthetics of the house, so instead we discussed the option of connecting the new boiler to the old chimney system. This

Read more

Dampers and Valves | Jeremias Group - chimney systems

Dampers. Flue gas dampers (butterfly valve) are installed in the connection pipe between a boiler and the chimney and close the flue gas path, if the chimney is no longer in use. This prevents the cooling down of the heat generator and the installation room, which helps to save energy. Furthermore in the case of cascade systems, you also avoid

Read more

55 0 tons of hospital biogas boiler chimney

References | Jeremias UK - chimney systems Chimney for the extraction of the waste air of lacquering systems with 15000m3at 350ºC. Based on several demands of the customers the chimney has been equipped with 4 platforms (2x135º/1x180º/1x360º as platform).

Read more

Commercial Gas Boilers-Thermal Oil heater

Welcome to Ideal Commercial BoilersIdeal Commercial Boilers, one of the most respected names in the UK heating industry, has been operating from its Hull manufa Commercial Gas Boilers-Thermal Oil heater

Read more

Contact Jeremias UK | Jeremias UK - chimney systems

Biomass boilers (woodchips, pellets, firewood…) are characterized by always working in a natural draft characteristic and are regulated by the fan in and or out of the combustion chamber to reduce fuel fire inside the chamber of combustion. This operating system requires that the chimney flue to be as stable as possible to avoid influencing the

Read more

gas boilers systems

Gas Boilers - eComfort: 969 Veterans Parkway C, Bolingbrook, 60490, Illinois Gas boilers | Jeremias UK - chimney systems The burners can be gas or diesel, which does not affect the characteristics of the chimney, except in the case of gasoil with high sulphur

Read more

Easy Calc 5.0 | Jeremias Group - chimney systems

The software allows you to choose among all the Jeremias chimney systems, choose your appliance characteristics, and make a quick chimney calculation. A small report is generated so you can include it in your projects. This Version EasyCalc 5.0 includes four different sizing possibilities: -Stoves. -Boilers. -Gen-Sets. -Multiple Header

Read more

Condensation Of Flue Gases In Boilers - ANCHORAGE …

Condensing boilers | Jeremias UK - chimney systems The high efficiency of the condensing boilers results from the fact that heat produced in the condensation process is used to increase heat supply. The exhaust gases are cooled well below 120°C hence the maximum condensate happens in the flue system chimney.

Read more

Heating Oil/Gas/solid fuel | Jeremias Group - chimney …

I n contrast to older boilers the exhaust gas temperature is far below 200ºC. Modernization of heating system therefore requires adapting your chimney to these temperatures. A reduction of the cross section is made through the construction of a exhaust pipe in the existing chimney.

Read more

Related Information